60Patrol

I know this has been addressed elsewhere but I can't find what I need to know. I waterproof distributor seems to be shot ironically Rusty. I bought a P-40 distributor but the end of the shaft is too big to get through the distributor stand or mount. Wondering if anybody has dealt with this and fixed it or did I just buy the wrong distributor. Here's some photos thanks so much

Is your new dizy 1.063"/27mm diameter?

Not seeing any pictures.

It won't let me add pictures it's saying the image must be at least 0 pixels High blah blah blah

If you're willing to send me an email or phone number I can get them to you that way thanks for any help

This forklift distributor is a direct replacement I'm told

https://www.sourcefy.com/distributor-22100-c7000/

Here's the original post

viewtopic.php?f=20&t=4868&p=48677&hilit ... tor#p48677

Thats the one that i b ought. the bottom part does not fit through the distributor stand.Now that I just wrote that I wonder if i can remove the bottom put it through the housing and put it back together?

Hmmm.....I know some peeps on here have found a direct forklift replacement hopefully someone will chime in soon.

Zoltar58 wrote:Thats the one that i b ought. the bottom part does not fit through the distributor stand.Now that I just wrote that I wonder if i can remove the bottom put it through the housing and put it back together?

Are you saying the drive on the bottom of the shaft is larger in diameter than the mounting shank of the distributor body?

What's the part number on the distributor body you received new?

Resize your pictures to less than 1024 high x 1280 wide and they will post.

I don't have the number in front of me but it was the number referenced in the above post