60Patrol

An open forum for all enthusiasts of the classic 60 series Nissan Datsun Patrol to gather and share information and gain knowledge. Members share off-road stories, restoration advice, modification ideas in an atmosphere free of a single controller. The fo
https://www.60patrol.com/forum/

Set Point Gap

https://www.60patrol.com/forum/viewtopic.php?t=1439

Page 1 of 1

Set Point Gap

Posted: Mon Jun 23, 2008 10:52 pm
by npca-stryder2000441
I feel like I am wallowing in ignorance. Could someone please explain to me how to set point gap? When I attempt to loosen point screw. the whole plate seems to move. The screw moves laterally in a little slot but does not seem to effect gap. ?!? My dwell is reading about 34 degrees. Is this close enough?

Set Point Gap

Posted: Sun Jul 06, 2008 9:32 am
by npca-gruntly
just loosen the screw a little bit then pry it with a screw driver in the slot with the pimple in it set to .20 thou about ok
All times are UTC-05:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited