Page 1 of 1

water pump

Posted: Thu Oct 08, 2020 5:52 pm
by Dave60
I have 69 g60 that I need a water pump for Are they still available and information would be great.

Re: water pump

Posted: Thu Oct 08, 2020 6:35 pm
by RiverPatrol
These folks can rebuild yours: http://www.kelloggautomotive.com

Re: water pump

Posted: Fri Oct 09, 2020 5:54 pm
by Dave60
great thanks !!

Re: water pump

Posted: Sun Mar 21, 2021 4:14 pm
by zed
Will this water pump fit the P engine? (I had read some earlier posts of some water pumps having zerk fitting. This pump does not appear to have such.)

Also, this pump has been sitting on a shelf for several years. Do you think the seals and gaskets would still allow the pump to function and not leak?

Finally, what does it cost to have Kellogg Automotive rebuild a pump?

Thanks,
Keith

Re: water pump

Posted: Sun Mar 21, 2021 5:59 pm
by Esteban
zed wrote:Will this water pump fit the P engine? (I had read some earlier posts of some water pumps having zerk fitting. This pump does not appear to have such.)

Also, this pump has been sitting on a shelf for several years. Do you think the seals and gaskets would still allow the pump to function and not leak?

Finally, what does it cost to have Kellogg Automotive rebuild a pump?

Thanks,
Keith
That pump will fit perfectly! :clap: :clap: :clap:

This is a revised model, with a sealed bearing. From my own experience with this type of pump, it will outlast the "zerk-type" by far.

Being a sealed bearing, it will be ok, and since the seal is actually a carbon face touching the impeller, nothing to go wrong there. Either buy it, or I'll pm you with my address :twisted:

Re: water pump

Posted: Sun Mar 21, 2021 7:09 pm
by zed
Esteban wrote:
zed wrote:Will this water pump fit the P engine? (I had read some earlier posts of some water pumps having zerk fitting. This pump does not appear to have such.)

Also, this pump has been sitting on a shelf for several years. Do you think the seals and gaskets would still allow the pump to function and not leak?

Finally, what does it cost to have Kellogg Automotive rebuild a pump?

Thanks,
Keith
That pump will fit perfectly! :clap: :clap: :clap:

This is a revised model, with a sealed bearing. From my own experience with this type of pump, it will outlast the "zerk-type" by far.

Being a sealed bearing, it will be ok, and since the seal is actually a carbon face touching the impeller, nothing to go wrong there. Either buy it, or I'll pm you with my address :twisted:
Esteban,
Thanks for the confirmation!
I made the seller an offer...if he doesn't accept you are next in line.
Keith

Re: water pump

Posted: Sun Mar 21, 2021 7:18 pm
by Esteban
Thanks Keith.

I’m actually ok regarding the water pump. Have one that I rebuilt myself as a spare, and installed is one sourced from Colombia since 2012. Might be made over there.

Both pumps are like the one in your picture.


Esteban