60Patrol

Hi all,


I found something that works pretty well for the screw in seal where the bottom of the doors meet the floorpan - thought I'd FYI you ...
The thickness of the tongue is just right to slide into the groove provided by the edge of the floorpan too
I re-used the same holes that were already there for the original seal which has been long gone... I just got new sheet metal screws & washers.

McMaster p/n 1142A82
https://www.mcmaster.com/#1142a82/=158k63l

See install pics below:

That's great. I think yours was one of the few that still had enough remnant of the original to cross reference from. Thanks for sharing!

Eric,

Thanks for that! Just ordered the rubber and some nice stainless steel screws and washers from Mcmaster Carr. It looks like a great fit.

Rick