Yet another transmission question

Won't run? Engine, cooling system, fuel pump, carb, clutch, tranny, brakes, etc. The old messages from the NPCA 'Engine & Mechanical' category are here.
Locked
So, I just bought this Patrol….
So, I just bought this Patrol….
Posts: 39
Joined: Tue Nov 20, 2012 7:34 pm
Location:

Yet another transmission question

Post by npca-honda guy »

Can anyone with a tranny out of their vehicle measure the length of the input shaft for me? I am working on somthing and didn't want to pull my trans just for the measurment if someone else had a trans on the floor. Thanks all!
You know you own a Patrol when…
You know you own a Patrol when…
Posts: 288
Joined: Tue Nov 20, 2012 7:34 pm
Location:
Contact:

Yet another transmission question

Post by npca-danetteandkeith »

The shaft is 7" overall. It is 5 1/4" to the end of the splines.
So, I just bought this Patrol….
So, I just bought this Patrol….
Posts: 15
Joined: Tue Nov 20, 2012 7:34 pm
Location:

Yet another transmission question

Post by npca-patrolfever »

; Hello guy's is any one knows ; if a vortec 4.3V6 is a good set up for the patrol, I have one 1997 for ; sell. my # 310 877-5959 John ; ; ----- Original Message ----- ; From: ; Danette & ; Keith ; To: Nissan Patrol Club ; Albuquerque ; Sent: Monday, December 06, 2004 3:07 ; PM; Subject: Re: Yet another transmission ; question; ; ; ; ; New Message on Nissan Patrol ; Club Albuquerque; ; ; Yet ; another transmission question; ; ; ; Reply; ; ; ; ;  ; Reply to Sender   Recommend ; Message 2 in ; Discussion ; ; ; ; ; ; From: Danette & Keith ; ; ; The shaft is 7" overall. It is 5 1/4" to the end of the ; splines.View other groups in this ; category.
Locked