Page 3 of 9

Re: Parting two 67's

Posted: Mon Dec 07, 2015 7:10 pm
by RMP&O
I got one of the 67's in the shop.

Here is the list of people/parts on the 1st come 1st serve;

Timoun: front leaf pack, I got several
r1lark: ash tray, I got one - hand crank, I may have one
Weasel1451: LHS window reg. I got one
2869ral: wiper arms, I got these but need to check condition
ShawnePatrol: brake mast w/cap, I have this - pass inner door handle, I got this - pre-69 steering wheel, I got this un-cracked - fuel pump, I have this - generator, I may have a spare - glass fuel bowl, can't spare this at this time
RonB: all cooling system parts, I got all this including a good radiator
Marshall: mirrors & front bumper, all I may have is inside mirror
Pdub: 16" wheels, sorry don't have - green/red dash lights, I got this
tnPatroller: glass done light, I got this - side steps, sorry they are not even worth shipping costs
jwgreen: door window handle, I got this - battery cover, I think I have this - knobs for vents, I got these - heater intake, I won't have a good hose but do have the assembly that mounts on the side of the radiator
ckhorne: clutch over, I got this

Pics and prices to come soon!

Cheers

Re: Parting two 67's

Posted: Mon Dec 07, 2015 7:17 pm
by RMP&O
Oh ya,

G60Michael: windshield hold down latches on hood - I have a set. Thing is I am not sure they are worth shipping to Oz. A pair from a later Patrol, ie 68+ will suit you fine but you need two Patrols to get a pair from the later Patrols. Shipping anything to Oz from where I live will be expensive.


Cheers

Re: Parting two 67's

Posted: Mon Dec 07, 2015 8:39 pm
by jwgreen
Ian,

I was recently told the 67 window handles will not work on my 69. If this is true then I will not need those. If they will work I will need the trim rings as well. The metal heater intake is what I am needing. I will make a new hose for it.

Re: Parting two 67's

Posted: Tue Dec 08, 2015 5:31 pm
by pdub
How about 3 split rims.

Re: Parting two 67's

Posted: Wed Dec 09, 2015 3:55 pm
by Timoun
Hi again-

I could also use a front drive shaft in addition to the one front spring pack.

Thank you!

Re: Parting two 67's

Posted: Thu Dec 10, 2015 1:55 pm
by RMP&O
pdub wrote:How about 3 split rims.
Ya, I got that.
Timoun wrote:Hi again-

I could also use a front drive shaft in addition to the one front spring pack.

Thank you!
I got this too.


Been pulling a few parts between working on Patrol projects. Got the window regulator pulled, wiper arms, door handles, ash tray and couple other items.

Cheers

Re: Parting two 67's

Posted: Fri Dec 11, 2015 12:07 am
by Marshall
Thanks for any mirrors you may have!

I figured I may as well do a full sweep on my 67 and get anything you may have. Depending on availability and cost, hopefully I can complete all missing details. Who knows when another donor 67 will come up with a willing mechanic to pull parts. :D

Green/red dash lights. (Pdub got a set, do you have another set?)
Master cylinder reservoir with cap. (ShawnePatrol got the first full mc, I just need reservoir and cap)
Door swing stays/catches (Not sure if these can be removed and reused, as mine are missing)
Rear red little circular reflectors.
All pedal pads: gas, brake, clutch.
Glovebox handle.
Rear metal Nissan Patrol badge.
Nissan hood emblem.
Fuel cap.
Dash light, complete with wiring and switch.

Thanks for your generosity of your time pulling all these parts for us all. :clap:

Re: Parting two 67's

Posted: Fri Dec 11, 2015 10:21 pm
by Coyote Patrol
Wiper arms dont have to be pretty, im painting them anyway. :D

Re: Parting two 67's

Posted: Sat Dec 12, 2015 11:00 am
by Urban60
Do you have two straight doors? with little rust? and the door latch and catches? drivers side regulator? right side ambulance door? :D

Re: Parting two 67's

Posted: Tue Dec 15, 2015 3:42 pm
by RMP&O
My responses to your inquiry Marshall inserted into your post in bold.
Marshall wrote:Thanks for any mirrors you may have!

I figured I may as well do a full sweep on my 67 and get anything you may have. Depending on availability and cost, hopefully I can complete all missing details. Who knows when another donor 67 will come up with a willing mechanic to pull parts. :D

Green/red dash lights. (Pdub got a set, do you have another set?) Right now I only have one set but I may have more soon.
Master cylinder reservoir with cap. (ShawnePatrol got the first full mc, I just need reservoir and cap) Sorry I can't help with the bowl and cap
Door swing stays/catches (Not sure if these can be removed and reused, as mine are missing) Ya I got these, if your truck matches a 67
Rear red little circular reflectors. Sorry, nadda
All pedal pads: gas, brake, clutch. Gas is vulcanized to the pedal, clutch and brake are available from Datsunland unless yours is a 68+ then you can get them out of Australia.
Glovebox handle. I got this
Rear metal Nissan Patrol badge. I just saw one the other day on Ebay, search seller "metricTLC" that is who made the reproductions originally, I don't have any good ones.
Nissan hood emblem. I got this
Fuel cap. I got this but with no key! I can try to pick the lock or you can buy it with the filler pipe and figure out how to get the cap off on your own.
Dash light, complete with wiring and switch. Do you mean the map light? If so I have this, might even have a glass cover for it too.

Thanks for your generosity of your time pulling all these parts for us all. :clap:
2869ral wrote:Wiper arms dont have to be pretty, im painting them anyway. :D
I got one set for you so far, in near perfect condition.
Urban60 wrote:Do you have two straight doors? with little rust? and the door latch and catches? drivers side regulator? right side ambulance door? :D
I don't have good doors. There is some rot in the bottom of them and a few dents. I do have door latches and catches (unless already claimed), I do have the regulator (unless already claimed) and maybe a rear door. Unlikely the rear door in good condition though, both parts trucks have rear end damage.



Sorry for the delay folks, my computer went down 4-5 days ago. Lost my HD, had to fix it, still don't have email working. Camera battery charger is missing too, need to locate that still. Home made farmers style snow plow set up had to be removed to get at parts (in engine bay) and that has been a real chore. Such a mess but I got it all off last night. After it was removed I could see I do have the glass fuel filter bowl requested earlier in the thread. Like I said before, one of these trucks runs, the green one. I hadn't touched the truck since last May, battery still hooked up. To my surprise, the horn works! 8-)

I am making progress slowly, pulling parts, setting aside the parts with the name of those who wanted them on the parts. Here is a few pictures of the Patrols I am parting.

Engine bay on 67 plow truck before removing plow stuff, this is the one that runs. 55,000 miles on it
Image

Engine bay on other 67
Image

green 67 plow truck before tear down
Image

Cheers