Re: Speedometer
Posted: Wed Jun 12, 2013 8:49 pm
Try a magnet if you cannot reach it.
A new one is the ticket.
Nice to see you after things!
A new one is the ticket.
Nice to see you after things!
60Patrol
An open forum for all enthusiasts of the classic 60 series Nissan Datsun Patrol to gather and share information and gain knowledge. Members share off-road stories, restoration advice, modification ideas in an atmosphere free of a single controller. The fo
https://www.60patrol.com/forum/
Speedometer
Page 3 of 5
Re: Speedometer
Posted: Thu Jun 13, 2013 3:13 pm
Success! Speedo works! Got a cable from a local parts store. Now to Napa to get a fuse box.
Re: Speedometer
Posted: Thu Jun 13, 2013 4:51 pm
Were gonna need that cable part # in compatibles for sure!Andrew wrote:Success! Speedo works! Got a cable from a local parts store. Now to Napa to get a fuse box.
Re: Speedometer
Posted: Thu Jun 13, 2013 4:57 pm
Yes, get us that part# please and where you got it.Andrew wrote:Success! Speedo works! Got a cable from a local parts store. Now to Napa to get a fuse box.
Re: Speedometer
Posted: Thu Jun 13, 2013 5:50 pm
I got the cable at Knechts. It is ATP brand part number Y-872. Here is a link to one on Amazon. http://www.amazon.com/ATP-Y-872-Speedom ... B000C8TBL4
Re: Speedometer
Posted: Thu Jun 13, 2013 11:19 pm
Cool, ordered it. Got me a spare now.Andrew wrote:I got the cable at Knechts. It is ATP brand part number Y-872. Here is a link to one on Amazon. http://www.amazon.com/ATP-Y-872-Speedom ... B000C8TBL4
Re: Speedometer
Posted: Fri Jun 14, 2013 1:15 am
Is there a wiring diagram available for Andrews 69, I'm trying to help him get his headlamps working. The 69 i have doesn't have a complete harness so i can't trace all the wires down. Thanks i would appreciate any help.
Re: Speedometer
Posted: Fri Jun 14, 2013 3:51 am
From earlier in this thread... Didn't shed any light?
Quick reference.. note there are a couple of extra's added over time
B- Black
R- Red
W- White
G- Green
Y- Yellow
L- Blue
'69 wiring diagram.. http://60patrol.com/forum/viewtopic.php?f=32&t=1671miller wrote:I've just been looking closer at your fuse block and the fuse that's missing is a 10a for the stop lamp switch.
Headlamp is second from the right. Power in at the top, out at the bottom. Do you have power at the bottom? You should also check if there is power at the foot dimmer switch because regardless of high beam or low beam all headlamp power runs from the dash switch, through the dimmer and then to the lamp.
Quick reference.. note there are a couple of extra's added over time
B- Black
R- Red
W- White
G- Green
Y- Yellow
L- Blue
Re: Speedometer
Posted: Fri Jun 14, 2013 9:33 am
There are wiring diagrams in the Patrolabilia category. There is a '69 specific wiring diagram here: http://www.60patrol.com/forum/viewtopic.php?f=32&t=1671
Re: Speedometer
Posted: Fri Jun 14, 2013 9:42 am
Thanks Miller and River Andrew called me last night and i tried walking him through testing the fuse box with a volt meter, which worked we tested it first. He said there was no voltage to any of the top terminals to the fuse box. Which doesn't make sense. Looking at the wiring diagram if there was no voltage at the first terminal(closest to the fire wall) the vehicle wouldn't start and run, and it does. I believe the corrosion on the fuse box is hampering a good reading to the volt meter. So at this point i think all the wire, screw, and fuse clip connections need to be cleaned along with the fuses. I think this will solve a lot of the problems. Also the fuse clips on this box are replaceable, I have some xtra clips if you want them Andrew. 
Andrew called me last night and i tried walking him through testing the fuse box with a volt meter, which worked we tested it first. He said there was no voltage to any of the top terminals to the fuse box. Which doesn't make sense. Looking at the wiring diagram if there was no voltage at the first terminal(closest to the fire wall) the vehicle wouldn't start and run, and it does. I believe the corrosion on the fuse box is hampering a good reading to the volt meter. So at this point i think all the wire, screw, and fuse clip connections need to be cleaned along with the fuses. I think this will solve a lot of the problems. Also the fuse clips on this box are replaceable, I have some xtra clips if you want them Andrew.