Wix oil filter replacement
-
- So, I just bought this Patrol….

- Posts: 65
- Joined: Thu Oct 07, 2021 7:00 am
- Location: St George Island, Fl
- Has thanked: 48 times
- Been thanked: 147 times
- Contact:
Wix oil filter replacement
Help, again. Please. Replacing oil filter with new Wix filter. New filter came with three different sized o rings. Am I looking for the one that fits outside the filter housing, below the housing into the housing groove or inside the housing? I did not remove an o ring when I removed oil filter housing and old filter. Weird?
Thanks. Everyday is a an adventure.
Dave
Thanks. Everyday is a an adventure.
Dave
You do not have the required permissions to view the files attached to this post.
- Administrator

- Posts: 7817
- Joined: Thu Oct 04, 2012 10:42 am
- Location: Temecula, CA
- Has thanked: 7696 times
- Been thanked: 2477 times
- Contact:
Re: Wix oil filter replacement
There is an o ring in that groove, if there wasn't your oil filter housing would have been leaking badly. It usually requires digging the old one out, it's pretty deep in there.
Beyond any hope for intervention

-
- So, I just bought this Patrol….

- Posts: 65
- Joined: Thu Oct 07, 2021 7:00 am
- Location: St George Island, Fl
- Has thanked: 48 times
- Been thanked: 147 times
- Contact:
Re: Wix oil filter replacement
Yes, you are right, as always. On further inspection I was able to dig the old one out and replace with new one. All good now.
Thank you.
Dave
Thank you.
Dave
- Patrol Fanatic!

- Posts: 3000
- Joined: Sat Feb 23, 2013 11:28 am
- Location: Lutherville, MD
- Location: Lutherville, MD
- Has thanked: 6011 times
- Been thanked: 1600 times
Re: Wix oil filter replacement
You have 3 O-rings, pictured below:
#3 At the top, outside the canister
#8 Goes in Washer/Retainer #9. This is crucial. Without it the oil is not filtered!
#4 Goes in the groove of the main body, where the canister sits.
From what I remembered the oil filters came with #8 & #4 only.

#3 At the top, outside the canister
#8 Goes in Washer/Retainer #9. This is crucial. Without it the oil is not filtered!
#4 Goes in the groove of the main body, where the canister sits.
From what I remembered the oil filters came with #8 & #4 only.

Owner of the same Patrol since 1967
-
- So, I just bought this Patrol….

- Posts: 50
- Joined: Mon Sep 28, 2020 8:50 am
- Location: Lower Slobbovia
- Has thanked: 22 times
- Been thanked: 113 times
Re: Wix oil filter replacement
Don't forget 3 and 8. I don't think they are included with the Wix currently. They are inch size o-rings that you can match up from the common o-ring kits available. Next time I do a filter change I will note the sizes if these o-rings and post them for future reference.Esteban wrote:You have 3 O-rings, pictured below:
#3 At the top, outside the canister
#8 Goes in Washer/Retainer #9. This is crucial. Without it the oil is not filtered!
#4 Goes in the groove of the main body, where the canister sits.
From what I remembered the oil filters came with #8 & #4 only.
- I love driving my Patrol!

- Posts: 635
- Joined: Sun Jul 19, 2015 4:36 pm
- Location: USA
- Location: North Carolina, USA
- Has thanked: 455 times
- Been thanked: 789 times
- Contact:
Re: Wix oil filter replacement
I know this is an old thread, but in case others in the future are searching for the oil filter seals ("O-rings")..........
Nissan still stocks the factory original oil filter for our Patrols as of May 2022, and it includes all three of the required and correct seals! The p/n is 15208-32225.
Here are some pics:'
Nissan still stocks the factory original oil filter for our Patrols as of May 2022, and it includes all three of the required and correct seals! The p/n is 15208-32225.
Here are some pics:'
You do not have the required permissions to view the files attached to this post.
Paul
-
- Patrol Newbie

- Posts: 8
- Joined: Sat Jul 11, 2026 11:38 am
- Location: Las Vegas Nevada
- Been thanked: 13 times
Re: Wix oil filter replacement
Hi there,
Do you happen to have the oil cannister replacement number from WIX?
thank you,
dmo
Do you happen to have the oil cannister replacement number from WIX?
thank you,
dmo
- Administrator

- Posts: 7817
- Joined: Thu Oct 04, 2012 10:42 am
- Location: Temecula, CA
- Has thanked: 7696 times
- Been thanked: 2477 times
- Contact:
Re: Wix oil filter replacement
Should be listed here: https://www.60patrol.com/forum/viewtopic.php?t=3381
Beyond any hope for intervention
