manual starting rod....1967 L-60

[faux40]

Not that I've tested it, but I've heard that the land rover handles will work and can be found on ebay
https://www.ebay.com/itm/255146481978?epid=13042710154

[r1lark]

Not that I've tested it, but I've heard that the land rover handles will work and can be found on ebay
https://www.ebay.com/itm/255146481978?epid=13042710154

See the fourth post in this thread. The Land Rover crank does work, but I had to cut about 1/8 to 3/16" off the end so the crosspin would fully engage the 'receiver' on the crank pulley. Mine came from Rovers North.

[faux40]

Not that I've tested it, but I've heard that the land rover handles will work and can be found on ebay
https://www.ebay.com/itm/255146481978?epid=13042710154

See the fourth post in this thread. The Land Rover crank does work, but I had to cut about 1/8 to 3/16" off the end so the crosspin would fully engage the 'receiver' on the crank pulley. Mine came from Rovers North.

Well, now I am embarrassed! Not sure how I missed your post!

Does it fit into the stock brackets and rubber blocks behind the seats? I've never 3d printed with TPU (flexible rubber filiment), but I think I could make a rubber insert for the stock clips

j

[RiverPatrol]

The blocks can be purchased here: http://www.new-datsun-parts.com/nissan- ... parts.html

[r1lark]

Does it fit into the stock brackets and rubber blocks behind the seats? I've never 3d printed with TPU (flexible rubber filiment), but I think I could make a rubber insert for the stock clips
j

I can't say whether it fits the clips and rubber blocks, have not tried it.

[hoyt]

hello.....do you still have crank rod....and mounting blocks? .if so how much you need to get it to 50595-1747.......iowa

This has suddenly become a hot topic. A few folks here have expressed interest in just the last couple of days. Please PM me. Sale pending, but if that falls through, you're next in line.

do u still have crank rod ?.........515-972-7246........hnajnra@yahoo.com

[Mr. Zero]

do u still have crank rod ?

I'm sorry, no. It shipped out to its new home yesterday.