Anyone have rear bumperettes for a 69?

[rjiggy]

Just for the record, the ones i had for the 67 did not fit the 69. Different bolt pattern.

Plateaucal is correct. I jus looked at Deuce, a 67 and Ducky, a 69. The sketch below describes the two different shapes of the frame members and slightly different dimensions of the mounting holes. These dimensions are nominal and taken with a tape measure in one hand, and flashlight in the other, so they are only for reference.

20181022_191205.jpg

Those of you waiting for your bumperettes, please let me know what type of frame member you have, or I can ship them to you with no holes drilled, your choice.

Thanks to Plateaucal for clarifying.

Rick

[RiverPatrol]

Also note that the ones with the cut out are for '69 and later.

[curlrider11]

Just for the record, the ones i had for the 67 did not fit the 69. Different bolt pattern.

Plateaucal is correct. I jus looked at Deuce, a 67 and Ducky, a 69. The sketch below describes the two different shapes of the frame members and slightly different dimensions of the mounting holes. These dimensions are nominal and taken with a tape measure in one hand, and flashlight in the other, so they are only for reference.

20181022_191205.jpg

Those of you waiting for your bumperettes, please let me know what type of frame member you have, or I can ship them to you with no holes drilled, your choice.

Thanks to Plateaucal for clarifying.

Rick

Yes thank you for the clarification! Rick I sent you an email with measurements from my 69 which are pretty close to the ones shown. Let me know if you got it okay. Thank you,

Ernest

[curlrider11]

Just got the bumperettes today in the mail Rick! They look great and the bolt hole placements are just right. can't wait to mount them up , will post photos when i do. Thanks again! Huge help!

[rjiggy]

I'm off to the supply house this morning to get some more steel. Anyone else looking for a set of these, let me know.
It may be a while before I fire up the bumperette press again.

Thanks,
Rick

[curlrider11]

Quick photo of Rick's handiwork mounted up .... Primed and test fit. Looking great! Thanks RICK!

[moore_rb]

RJiggy... Considered by many to be the GOAT when it comes to Patrol bumperettes...

I own two pairs of his work myself, and my only regret was that I didn't have him autograph them before he shipped them out.

[yuke175]

I’d like to get a set

[Edgar]

I would like an early set as well with no cutout. My Patrol is a '67.

[curlrider11]

Three month review after installing these on my patrol.... Gas mileage has improved by 4 mpg, fender rust spots have vanished, and my brakes don't pull to the right anymore. Absolutely amazing!

But seriously, great work Rick, love mine