Tool box

[Coyote Patrol]

Any chance someone could post some pics of a tool box? I need a pic of the hinge, pic of box closed and box open. Also the measurements. Depth, width, length, and also measurement of the separator . Im going to try and fab these. Thank you.

[Esteban]

I "borrowed" this pictures from another place. Hope it helps:

Tool box 1a.jpg

Tool box 2a.jpg

Dimensions

Length (outside): 13-5/8"
Width (outside): 8" (edit)
Depth (top open): 2-3/4"
Separator at back: 2-3/4"
Separator at front: 1-3/4"
Depth of separators: 2-1/2"

[Coyote Patrol]

Could you get me a pic of the handle, and clasps please. Thanks Esteban

[RiverPatrol]

Here's some:

[Coyote Patrol]

Thank you, where the handle goes into the box, was that pressed into the box? (like a louvre)

[bosque]

About the 6th shot down has another angle.
You are going to make the uber unobtainium toolbox not so impossible to have!

http://www.60patrol.com/forum/viewtopic.php?f=33&t=1937

[Coyote Patrol]

About the 6th shot down has another angle.
You are going to make the uber unobtainium toolbox not so impossible to have!

http://www.60patrol.com/forum/viewtopic.php?f=33&t=1937

Im gonna give it a shot, i have a lot of catching up to do, so it will be a while.

[Coyote Patrol]

Well some fine tuning is in order, but here is the rough stages of the stamp for the top and bottom of the tool box. The nissan symbol is going to take some time to carve. This is just a scrap piece of metal i used.

[RiverPatrol]

You're off to a great start! Very impressive.

[bosque]

Ron,
So out of curiosity, do you actually make a nissan emblem and then press or emboss it into the sheet metal?
It is so cool to see you doing this stuff, I wish I were a fly on the wall.