60Patrol

Does anyone know a generic part that is interchangeable with the BUMPER-CARRIER (part number 57291-44000)?
See Item number 34 on illustration:

http://www.carpartsmanual.com/nissan-pa ... fault.aspx
Thanks,
Keith

Try steele rubber products under suspension parts. There are several chassis rubber plugs that may fit the bill.

Do you have a photo (and measurements) of the actual plug?
Thanks, in advance...I have nt been able to find one on the World Wide Web.
Keith

1" x 1" rubber bumper generic: http://parts.mirageinc.com/1-rubber-bumper

Tell us what worked.
The axel on the carriers get worn and elongated the hole so either fix the holes and get new rubber or use a spacer/base under the rubber to make it squish hard so the bloody spare will stop squeaking/rattling.

Here is a photo of an original 1967 plug:


1-1/20" high (from mounting surface to crown)
1-1/10" wide (at base)

I was not able to remove the mounting stem, so I do not have the dimensions.

Naturally, 47 year old rubber shrinks, so I am not certain of the original dimensions.

Please post photos of your contemporary replacement part.
Thanks,
Keith

The mounting stud is approx. 1/2" long and its 10×32 thread pitch.

Im too cheap, or maybe i just like making my own parts.

All I can say is "very nice".
This is the closest I have found off-the-shelf.

Are you planning to offer any for sale/trade?
Keith

Sure i can make you some if you would like.