PTO Seal

Wiring diagrams, Spring specs, etc

Postby L60Boerne » Sat Oct 22, 2022 6:16 pm

Greetings, I need to install new seals in the transfer case and PTO shifter seal after Access Transmission in San Antonio butchered the complete transmission rebuild this summer.

Concerning the PTO shifter seal..... I typically use a metric 15 x 30 x 10 seal. However, in this case the ID fits around the shaft but the OD is perhaps 1/2 mm too small, leaving a clear OD gap. Has anyone else experienced this? It there a different seal I need? Given it location it is unlikely to leak but I hate leaks so if there is a better solution I'd sure appreciate the news.

Rolling and Patrolling,
L60Boerne
63 Soft Top - Command & Control Vehicle 5 (CCV5)
65 No Top - Presidio Patrol (CCV4 -sold)
65 No Top - Santa's Sleigh
66 Soft Top - Phoenix Patrol (CCV6) For Sale
66 No Top - Pinto Patrol (CCV7)
L60Boerne Offline


Helping others revive their Patrol…
Helping others revive their Patrol…
 
Posts: 1818
Images: 0
Joined: Wed Mar 23, 2016 4:50 am
Has thanked: 6 times
Been thanked: 1690 times
Location: Boerne, Texas

Return to Technical Information

Who is online

Users browsing this forum: No registered users and 1 guest