Search found 152 matches
- Tue Jul 21, 2015 11:15 am
- Forum: How To's
- Topic: How-To: Wiring a GM 3-Wire Alternator into your Patrol
- Replies: 10
- Views: 12585
Re: How-To: Wiring a GM 3-Wire Alternator into your Patrol
hi, I'm trying to follow the guidance in this thread - but the photos are not coming through. can you re upload the photos?
- Thu Jul 09, 2015 3:04 pm
- Forum: Engine and Mechanical
- Topic: Voltage Regulator Question/Replacement
- Replies: 12
- Views: 5493
Re: Voltage Regulator Question/Replacement
thanks for the posting on the service manual. I reviewed the voltage regulator section - and its a bit too complicated for me. I think I will need someone to repair the regulator for me, or I will need to purchase a replacement. in the meantime, I can still enjoy the patrol - i'll just plan on charg...
- Thu Jul 09, 2015 12:55 pm
- Forum: Engine and Mechanical
- Topic: Voltage Regulator Question/Replacement
- Replies: 12
- Views: 5493
Re: Voltage Regulator Question/Replacement
No I didn't do that. I wasn't sure what the instructions to do that are.
- Thu Jul 09, 2015 11:52 am
- Forum: Engine and Mechanical
- Topic: Voltage Regulator Question/Replacement
- Replies: 12
- Views: 5493
Re: Voltage Regulator Question/Replacement
I tried installing a brand new ford voltage regulator for a generator - it has the same selection of wires - arm, field, batt, ground. it seemed to turn the generator into a motor. I tried the polarizing task as noted - saw the spark - but it didn't seem to help it. So, would it be possible for me t...
- Wed Jul 08, 2015 1:40 am
- Forum: Parts and Compatible Parts
- Topic: Rollbar for patrols?
- Replies: 12
- Views: 4420
Re: Rollbar for patrols?
Thats very nice. Can u give me an approx weight and dimensions? I can list it on uship to see a cost.
- Tue Jul 07, 2015 11:37 pm
- Forum: Engine and Mechanical
- Topic: Voltage Regulator Question/Replacement
- Replies: 12
- Views: 5493
Re: Voltage Regulator Question/Replacement
I will try that tomorrow. In the meantime, i was thinking maybe i dont need a generator? Its a little crazy, but if i dont use any accessories and i only start the patrol by the hand crank, how long could i go before needing to charge the battery? And how low voltage can the battery be and still be ...
- Mon Jul 06, 2015 7:20 pm
- Forum: Parts and Compatible Parts
- Topic: Rollbar for patrols?
- Replies: 12
- Views: 4420
Rollbar for patrols?
I read a previous thread that says a toyota cj 7 will fit, just a little short.
I decided to remove my hardtop so i wont need to worry anout any hardtop clearances. Let me know if anyone is selling a rollbar. Thanks
I decided to remove my hardtop so i wont need to worry anout any hardtop clearances. Let me know if anyone is selling a rollbar. Thanks
- Mon Jul 06, 2015 11:26 am
- Forum: Engine and Mechanical
- Topic: Voltage Regulator Question/Replacement
- Replies: 12
- Views: 5493
Re: Voltage Regulator Question/Replacement
that's great. is there a certain gap I should set it to - like a dwell gap of 0.017 inches?
- Mon Jul 06, 2015 9:18 am
- Forum: Engine and Mechanical
- Topic: Voltage Regulator Question/Replacement
- Replies: 12
- Views: 5493
Voltage Regulator Question/Replacement
hi guys, my battery started running down on the '67 patrol and I then observed that the generator is not charging the battery. I removed the generator and brought to the local shop - and they tested it and said its fine. I then reinstalled it and tried one of my ford voltage regulators for generator...
- Thu May 14, 2015 1:02 am
- Forum: Electrical
- Topic: Dash Wiring question
- Replies: 4
- Views: 3933
Re: Dash Wiring question
thanks esteban! i checked the wiring diagram and sure enough the green/white, and black wires dangling near the gages is for the dash mounted light. I hadn't noticed those wires a few months back and i found another source of power for the dash light. i'll fix it back up so its wired correctly.