60Patrol

would that be the adjuster screw?

It started right up after buttoning everything up but it is misfiring pretty bad. It'll stall under any load so I gotta diagnose that problem and fix that.

Interesting It looks different than the one I ordered. Do you need to ground the new kits plate to the distributer? I didn't get a cable to ground the distributor to the new electronic ignition kit plate?

Great! Thanks for the Help. Would yall be able to send photos of the installed 1763ls and it connected to the coil?

Ok, so according to the chart I should get the 3 ohms 40,000 volt 40511 coil? or the 1.5, because I was looking at someone else's post and someone linked the 1.5. Then for ignition kits the 1168LS is for non water protected and 1763Ls for water protected distributors. Right? Where does the 1761 kit ...

Appreciate the advice from you both of you, I'm think of headed towards the electronic ignition kit. From the very little research I've done so far it seems like a quick fix. I checked the website, I'm assuming the kit part number 1168LS is the right one. Thought I would double check. Do you know if...

After installing the new rear end, the patrol ran great. However, after starting it up to drive home from errands one day, it began to misfire and lose power. I managed to limp it back home. Upon inspection, we found it wasn't getting a spark, even though the coil had power and the spark plugs and w...

I think I finally figured it out, if so let me know. More photos to come

I changed the camera to compatible but now its saying its to large of a photo (too many pixels) and when i edit it down to fit the size restrictions everything that needed to be in the photo got cropped out. And Ideas?

Ill try and send photos over as soon as possible. I'm busy this afternoon so Ill try again tonight